Rockwell Automation 2706-LV2P_LV2R_LV4P_LV4R DL40 PLUS USER MANUAL - Manual (Page 36)

Using the Onboard Editor to Create Messages 2–10
Publication 2706-6.1
Display Line
This value controls where on the DL40 Plus display the message will
appear. Options are different for 2 and 4 line versions. Use the
spacebar to move through the available choices, then press
[
↵
] when
you see the correct value.
With 2 line units, choose from With 4 line units, choose from
All Lines All Lines
Line 1 Only Line 1 Only
Line 2 Only Line 2 Only
Line 3 Only
Line 4 Only
Scroll Message
This message attribute determines whether the message will scroll
across the DL40 Plus display. You can activate scrolling only if the
Display Line attribute has been set to a single line. Type
[Y][
↵
] to
activate or [N][
↵
] to deactivate.
Print Message
If the Print message attribute is set to Y, then the DL40 Plus will
send any triggered message to a printer via the RS-232 port. The
message is printed only once (even if the Auto repeat attribute is
active) unless the message variable data changes. If new variable
data is received while the message is running, then the message will
be printed more than once. Type
[Y][
↵
] to activate or [N][
↵
] to
deactivate.
You must configure the RS-232 port for Programmer use.