beautypg.com

Introduction, Quick start – Rockwell Automation 6723-PCO DATA PROCESS CONFIG OPERATIO User Manual

Page 3

background image

Quick Start

QS

Publication 6723Ć10.1 Ć August 1996

Process Configuration and

Operation Software for

Windowst

(Catalog Number 6723-PCO)

This Quick Start introduces experienced PLC-5 processor users,
6200 software users, and new Process Configuration and Operation
software users to installing and using PCO software.

Note: You can also use AI software. However, for the purposes of
this Quick Start, we will be using 6200 software.

This document shows you how to set up a system using a typical
configuration. For the purposes of this Quick Start, we will use the
application example of a forced-air grain-drying system to illustrate
the procedures you will use to develop a process control system with
PCO software.

This application example will show you how to:

understand and define your process so that you can determine
your control requirements

develop PLC code for use with PCO

create Jump-to-Subroutine (JSR) instructions and Data Table files

configure your process functions and load the appropriate
information about these configurations into your PLC processor

This Quick Start includes:

basic information needed to start using the PCO application
quickly and effectively; we do not cover all PCO features

high-level procedures with cross-references to other publications
for more detail

Refer to the Process Configuration and Operation Software User
Manual
(publication 6723-6.5.1) for more specific information on
PCO functions and features.

Introduction