Rockwell Automation 1771-DB BASIC MODULE - Manual (Page 53)

3 Chapter
3 -1
Installing and Replacing Components
Refer to this chapter if you are installing or replacing a memory module or
the battery. If not, go on to Chapter 4, “Programming the BASIC
Module”.
This chapter describes: On page:
before you begin 3 -1
remove the BASIC module from the I/O chassis 3 -2
disassemble the BASIC module 3 -3
install memory module 3 -4
install the battery 3 -8
reassemble the BASIC module 3 -11
what’s next? 3 -11
Before you can install the memory module or battery you must remove the
module from the I/O chassis and disassemble the module. You need these
tools to do this:
Phillip’s head screwdriver
flat head screwdriver (for battery)
chip insertion/extraction tool (for memory modules without a carrier)
ATTENTION: To avoid damaging the module with
electrostatic discharge:
Wear an approved wrist-strap grounding device or touch a
grounded object to discharge yourself before
handling any equipment. (Note that the wrist
strap is not supplied with the module.)
Do not touch backplane connectors or
connector pins.
If you configure or replace internal components,
do not touch other circuit components inside the module.
When not in use, keep components in a static-shielded bag.
What’s in This Chapter?
Before You Begin
17991
Attach this end
to a good earth
ground.