beautypg.com

Input status 2 descriptions -7, Input status 2 descriptions – Rockwell Automation 1746-NO8V SLC 500 8-Point Analog Output Module/ User Manual User Manual

Page 51

background image

Publication 1746-UM026A-EN-P - September 2003

I/O Data and Status Information 5-7

Input Status 2 Descriptions

User Scaling Values Set (Status Bit 0)

This bit indicates that user scaling values have been set for this
channel. If the channel format is user scaling and the channel is
enabled, user scaling is active.

Clamping Values Set (Status Bit 1)

This bit indicates that clamping values have been set for the channel.
If the channel is enabled, then clamping is active.

Limit Alarm Values Set (Status Bit 2)

This bit indicates that limit alarms have been set for the channel. If the
channel is enabled, then limit alarms is active.

Ramping/Rate Limiting Value Set (Status Bit 3)

This bit indicates that ramping/rate limiting has been set. If the
channel is enabled, then ramping/rate limiting is active.

Preset Fault Value Set (Status Bit 4)

This bit indicates that a user-defined fault value is set for this channel.
See Fault Options (configuration bits 12 and 13) on page 4-10 for
information on fault settings and fault conditions.

Reset Output On Fault (Status Bit 5)

This bit indicates that the output for this channel will be reset if a
channel fault occurs. See Fault Options (configuration bits 12 and 13)
on page 4-10 for information on fault settings and fault conditions.

Hold Output On Fault (Status Bit 6)

This bit indicates that the channel output value will be held to the
current value when a channel fault occurs. See Fault Options
(configuration bits 12 and 13)
on page 4-10 for information on fault
settings and fault conditions.

Preset Output On Fault (Status Bit 7)

This bit indicates that the channel output will go to the user defined
preset when a channel fault occurs. See Fault Options (configuration
bits 12 and 13)
on
page 4-10 for information on fault settings and fault
conditions.

This manual is related to the following products: