Channel input status word 2 (class 3 only) -6, Channel input status word 2 (class 3 only) – Rockwell Automation 1746-NO8V SLC 500 8-Point Analog Output Module/ User Manual User Manual
Page 50

Publication 1746-UM026A-EN-P - September 2003
5-6 I/O Data and Status Information
Channel Input Status Word 2 (Class 3 Only)
Words 8 through 15 of the input image file (addresses I:e.8 through
I:e.15) reflect the parameter options, fault settings, and alarm options
for each channel. Input Status 2 addressing and bit definitions are
shown in the following figures:
Figure 5.4 Input Status 2
Input Image Words 0 through 7
Function
Input Status 2
Class 3
I:e.8
Channel 0
I:e.9
Channel 1
…
I:e.14
Channel 6
I:e.15
Channel 7
Table 5.4 Input Status 2 Word Details
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
User Scaling Values Set
1
Clamping Values Set
1
Limit Alarm Values Set
1
Ramping/Rate Limiting Values Set
1
Preset Fault Value Set
1
Reset Output on Fault
1
Hold Output on Fault
1
Preset Output on Fault
1
Alarms Will Be latched
1
Output at Low Clamp Alarm
1
Output at High Clamp Alarm
1
Low Limit Alarm
1
High Limit Alarm
1
Under Range Alarm
1
Over Range Alarm
1
Channel Configuration Error
1