Rockwell Automation 1746-NO8V SLC 500 8-Point Analog Output Module/ User Manual - Manual (Page 25)

1 Publication 1746-UM026A-EN-P - September 2003
Chapter
4
Configuring the Module
Read this chapter to:
•
enter the output module’s ID code
•
configure the module using the RSLogix 500 wizard
•
configure the module using output words (includes detailed
description of all configuration options and examples)
•
set the optional features (user scaling, clamping, limit alarm,
ramping/rate limit, and preset fault value)
•
review an example ladder program to configure Channel 0
To configure the module, you need:
•
programming equipment
•
RSLogix 500 programming software
Entering the Module ID
Code Before using the module, you must configure the chassis slot your
module is in by entering the module’s ID code in RSLogix 500.
When using RSLogix 500, version 6.10 or higher, simply select your
module from the list of modules on the system I/O configuration
display to automatically enter the ID code.
With earlier versions of RSLogix 500, you must manually enter the ID
code. To enter your module’s ID code, select “other” from the list of
modules on the system I/O configuration display, and enter your
module’s ID code at the prompt. The module ID code for your
module is:
If you perform the “READ IO CONFIG” option in RSLogix 500
programming software, version 6.10 or higher, the 1746-NO8 module
will automatically be configured in Class 3 mode. With earlier versions
of RSLogix 500, the module will be configured in Class 1 mode and
displayed with its Class 1 module ID code.
Table 4.1 1746-NO8 Module ID Codes
Catalog Number Module ID Code
1746-NO8I 3527 Class 1 Mode (8 inputs / 8 outputs)
12727 Class 3 Mode (16 inputs, 32 outputs)
1746-NO8V 3528 Class 1 Mode (8 inputs / 8 outputs)
12728 Class 3 Mode (16 inputs / 32 outputs)