Rockwell Automation 1746-NR8 SLC 500 RTD/Resistance Input Module User Manual User Manual
Slc 500™ rtd/resistance input module
Table of contents
Document Outline
- 1746-UM003A-EN-P, SLC 500 RTD/Resistance Input Module
- Important User Information
- Table of Contents
- Preface
- 1 - Overview
- 2 - Installation and Wiring
- 3 - Preliminary Operating Considerations
- 4 - Channel Configuration, Data, and Status
- Channel Configuration
- Channel Configuration Procedure
- Configure Each Channel
- Enter the Configuration Data
- Input Type Selection (Bits 0 through 3)
- Data Format Selection (Bits 4 and 5)
- Broken Input Selection (Bits 6 and 7)
- Temperature Units Selection (Bit 8)
- Filter Frequency Selection (Bits 9 and 10)
- Channel Enable Selection (Bit 11)
- Excitation Current Selection (Bit 12)
- Calibration Disable (Bit 13)
- Lead Resistance Measurement Enable (Bits 14 and 15)
- Channel Data Word
- Channel Status Checking
- Input Type Status (Bits 0 through 3)
- Data Format Status (Bits 4 and 5)
- Broken Input Status (Bits 6 and 7)
- Temperature Units Status (Bit 8)
- Channel Filter Frequency (Bits 9 and 10)
- Channel Enable Status (Bit 11)
- Calibration Error (Bit 12)
- Broken Input Error (Bit 13)
- Out-Of-Range Error (Bit 14)
- Configuration Error (Bit 15)
- 5 - Ladder Programming Examples
- 6 - Module Diagnostics and Troubleshooting
- 7 - Application Examples
- A - Specifications
- B - Configuration Worksheet for RTD/Resistance Module
- Glossary
- Index
- Back Cover