Set the counter’s parameters – Rockwell Automation 1734-VHSC24 Very High-Speed Counter Modules User Manual User Manual
Page 47
Publication 1734-UM003B-EN-P - August 2005
Configure Your Module 4-5
Set the Counter’s
Parameters
After adding the module to the network, you must configure the
modules for use. Use this procedure.
1. From the DeviceNet - RSNetWorx for DeviceNet dialog,
complete the actions shown in the figure.
You see a counter module dialog with a series of tabs at the top
of the dialog. See the tabs in the figure.
These dialogs are for the 1734-VHSC24 module. Use identical
dialogs for the 1734-VHSC5 module.
IMPORTANT
This procedure shows configuration in the online
mode. Changes set in this mode take effect when
you download to the individual module.
1. Right-click the module.
2. Click Properties to
configure your adapter.
You can also left-click the module or name
and the property dialog appears.
These are the tabs you click to
view the options.