Configure your module, What this chapter contains, Configuration overview – Rockwell Automation 1734-VHSC24 Very High-Speed Counter Modules User Manual User Manual
Page 43: Chapter

1
Publication 1734-UM003B-EN-P - August 2005
Chapter
4
Configure Your Module
What This Chapter Contains
This chapter describes how to configure your Very High-Speed
Counter modules with RSNetWorx.
Configuration Overview
Use RSNetWorx for DeviceNet software to configure your module.
You can configure the module while it is online or offline.
This chapter shows configuration in the online mode. Configuration
dialogs appear similar in both modes. The primary difference is that if
you make changes offline, you must go online before the
configuration changes take effect.
Add the Adapter to Your Network
Follow these steps to add an adapter to your network.
1. Start the RSNetWorx for DeviceNet software.
2. Add the communication device as shown in the figure, where
we chose a 1770-KFD RS232 Interface.
For More Information About
See Page
Add the Adapter to Your Network
Add I/O Modules to Your Network
4-2
Check I/O Status and View the EDS File
4-9
IMPORTANT
The scanner must always exist on the DeviceNet
network at Node 00.