Rockwell Automation 1336T Function Block Prog. Manual, Series A/B - Manual (Page 22)

1–10 Getting Started
1336 FORCE — 5.9 August 1995
Press the enter key to save the value as shown below.
Step 5 — Modify the Limit Block
1. Move to the Limit function block node entry field by clicking on
ID # 1 . Link the Limit’s input (node 0), to the Rate Limiter’s
output (node 5).
Click on the Link To field for Node 0 and enter 4:5 .
Press the enter key to save the value as shown below.
The block diagram is now complete and should appear as shown
below with the Rate Limiter function block added.
Input 1 1:0
Max Val (32767) 1:1
LIMIT
ID # 1
@ Max Lim !:3
@ Min Lim 1:4
Output 1:5 Min Val (–32767) 1:2
Set Reset FF
ID # 2
Set 2:0
Reset 2:1
Out1 2:2
Out2 2:3
Output 3:6 In1 (32767) 3:0
In2 (–32767) 3:1
In3 3:2
In4 3:3
Sel0 3:4
Sel1 3:5
Multiplexer
ID # 3
Lim @Lim 4:4 Lim In 4:0
Lim Set 4:1
Lim Data 4:2
Lim Rate 4:3 (65535)
Lim Out 4:5
Rate Limiter
ID # 4