Rockwell Automation 1305 AC Drive, Series C, Firmware 6.xx and Up - Manual (Page 116)

Programming 5-48
Masks Group (continued)
[Start Mask] Parameter # 95 Factory Default 01111111 [Start Mask]
Parameter Type Read & Write
This parameter determines which adapters can issue start
commands. Units Byte Settings 1
0
Permit Control
Deny Control
[Jog Mask] Parameter # 96 Factory Default 01111111 [Jog Mask]
Parameter Type Read & Write
This parameter determines which adapters can issue jog
commands. Units Byte Settings 1
0
Permit Control
Deny Control
[Reference Mask] Parameter # 97 Factory Default 01111111 [Reference Mask]
Parameter Type Read & Write
This parameter determines which adapters can control the
switching between the available freq. reference sources.
Important: Terminal Block (TB2) will have control unless
masked out. Units Byte Settings 1
0
Permit Control
Deny Control
[Accel Mask] Parameter # 98 Factory Default 01111111 [Accel Mask]
Parameter Type Read & Write
This parameter determines which adapters can switch
between [Accel Time 1] and [Accel Time 2].
Important: Terminal Block (TB2) will have control unless
masked out. Units Byte Settings 1
0
Permit Control
Deny Control
[Decel Mask] Parameter # 99 Factory Default 01111111 [Decel Mask]
Parameter Type Read & Write
This parameter determines which adapters can switch
between [Decel Time 1] and [Decel Time 2].
Important: Terminal Block (TB2) will have control unless
masked out. Units Byte Settings 1
0
Permit Control
Deny Control