Rockwell Automation 440C Guardmaster 440C-CR30 Configurable Safety Relay User Manual - Manual (Page 111)

Rockwell Automation Publication 440C-UM001C-EN-P - November 2014 111
Security and Password Chapter 16
Configure Password Set, change, and clear the password on a target safety relay through the
Connected Components Workbench software.
Set Safety Relay Password
In the following instructions:
• The Connected Components Workbench software is connected to the
Guardmaster 440C safety relay.
• The relay is loaded with a viable configuration.
• The configuration does not necessarily have to be verified.
• The CR30 can be in either program or run mode.
1. On the Connected Components Workbench software, open the project
for the target safety relay by double-clicking the safety relay in the Project
Organizer.
2. On the Device Details toolbar, mouse over the Secure button. The tooltip
message “Set, Change, or Clear Safety Relay Password Protection” is
displayed.
3. Click the Secure button. Select Set Password.
4. Provide password. Confirm the password by providing it again in the
Confirm field.
IMPORTANT The following instructions are supported on Connected Components
Workbench version 7 and Guardmaster 440C safety relays with firmware
revision 7.
TIP Passwords must have at least eight characters to be valid.