Compatibility, Work with a locked safety relay, Upload from a password-protected safety relay – Rockwell Automation 440C Guardmaster 440C-CR30 Configurable Safety Relay User Manual User Manual
Page 110: Connect to a password-protected safety relay, Download to a password-protected safety relay, Compatibility work with a locked safety relay
110
Rockwell Automation Publication 440C-UM001C-EN-P - November 2014
Chapter 16
Security and Password
Compatibility
The Safety Relay Password feature is supported on:
•
Connected Components Workbench version7 and later
•
Guardmaster 440C safety relays with revision 7 or later firmware
Users with earlier versions of the software and/or hardware are advised to
upgrade the software and firmware. See
Upgrade the Firmware on page 141
for
instruction on firmware upgrades.
Work with a Locked Safety
Relay
The following workflows are supported on compatible Guardmaster 440C safety
relays (firmware revision 7 or later) and CCW version 7 or later.
Upload from a Password-Protected Safety Relay
1.
Launch the CCW software project with your Guardmaster 440C safety
relay configuration.
2.
Double-click the Guardmaster 440C safety relay in the Project
Organizer to open the Safety Relay workspace.
3.
Select Upload from the pull-down menu in the safety relay header.
4.
Select the target safety relay in the Connection Browser.
5.
When requested, provide the safety relay password.
Connect to a Password-Protected Safety Relay
1.
Launch the CCW software project with your Guardmaster 440C safety
relay configuration.
2.
Double-click the Guardmaster 440C safety relay in the Project
Organizer to open the Safety Relay workspace.
3.
Select Connect from the pull-down menu in the safety relay header.
4.
Select the target safety relay in the Connection Browser.
5.
When requested, provide the safety relay password.
Download to a Password-Protected Safety Relay
1.
Launch the CCW software project with your Guardmaster 440C safety
relay configuration.
2.
Double-click the Guardmaster 440C safety relay in the Project
Organizer to open the Safety Relay workspace.
3.
Select Download from the pull-down menu in the safety relay header.
4.
Select the target safety relay in the Connection Browser.
5.
When requested, provide the safety relay password.