Rockwell Automation 22-COMM-D DeviceNet Adapter - Manual (Page 108)

B-4 Adapter Parameters
15 [DSI I/O Cfg]
Sets the configuration of the Drives that are active
in the Multi-Drive mode. Identifies the connections
that would be attempted on a reset or power cycle. Default: 0001
Values: 0 = Drive 0
1 = Drives 0-1
2 = Drives 0-2
3 = Drives 0-3
4 = Drives 0-4
Type: Read/Write
Reset Required: Yes
16 [DSI I/O Act]
Displays the Drives that are active in the
Multi-Drive mode. Default: 0001
Bit Values: 0 = Drive 0
1 = Drives 0-1
2 = Drives 0-2
3 = Drives 0-3
4 = Drives 0-4
Type: Read Only
17
18
19
20
21 [Drv 0 Addr]
[Drv 1 Addr]
[Drv 2 Addr]
[Drv 3 Addr]
[Drv 4 Addr]
Sets the corresponding node addresses of the
daisy-chained drives when the adapter Mode
Jumper (J2) is set for Multi-Drive operation.
Important: The settings for these parameters
must match the Parameter A104 - [Comm Node
Addr] settings in the respective drives. Each
setting must also be unique (no duplicate node
address).
Default: 1
Default: 2
Default: 3
Default: 4
Default: 5
Minimum: 1
Maximum: 247
Type: Read/Write
Reset Required: Yes
Parameter
No. Name and Description
Details