Rockwell Automation 22-COMM-E EtherNet/IP Adapter - Manual (Page 40)

4-4 Configuring the Scanner or Bridge
To transmit data between the scanner or bridge and the adapter, you must
add the 22-COMM-E adapter as a child device of the scanner or bridge.
1. In the Control Organizer pane, right-click on the scanner or bridge
and select New Module ( Figure 4.6 ). In our example, we right-click
on the 1756-ENBT/A bridge.
Figure 4.6 Right-Clicking on the Scanner
The Select Module Type dialog box ( Figure 4.7 ) appears.
Figure 4.7 Select Module Type Dialog Box
2. Select ETHERNET-MODULE to configure a 22-COMM-E
( Figure 4.7 ), and then click OK.
Adding the Adapter and Drive to the I/O Configuration