Rockwell Automation 22-COMM-E EtherNet/IP Adapter - Manual (Page 15)

Getting Started 1-3
The EtherNet/IP adapter is compatible with Allen-Bradley PowerFlex
Component Class drives and other products that support an internal DSI
adapter. At the time of publication, compatible products include:
• PowerFlex 40 drives
The Multi-Drive feature ( Chapter 7 ) also provides a means for
PowerFlex 4 drives and other DSI Hosts to connect to EtherNet/IP.
Equipment Shipped with the Adapter
When you unpack the adapter, verify that the package includes:
User-Supplied Equipment
To install and configure the EtherNet/IP adapter, you must supply:
Phillips is a registered trademark of the Phillips Screw Company.
Compatible Products
Required Equipment
❑ One EtherNet/IP adapter
❑ A 15.24 cm (6 in.) Internal Interface Cable
❑ This manual
❑ A small flathead or Phillips
®
screwdriver
❑ Ethernet cable (refer to the EtherNet/IP Media Planning and
Installation Manual, Publication No. ENET-IN001…, for details)
❑ Configuration tool, such as:
– PowerFlex 4-Class HIM (22-HIM-*)
– DriveExplorer (version 3.01 or higher)
– DriveExecutive (version 3.01 or higher)
– RSNetWorx for EtherNet/IP
– BOOTP Server (version 2.1 or higher) (network setup only)
❑ A PC connection to the EtherNet/IP network.
❑ Controller configuration software
(Examples: RSLogix5, RSLogix500, or RSLogix 5000)