Connecting the adapter to the drive – Rockwell Automation 22-COMM-E EtherNet/IP Adapter User Manual

Page 22

2-4

Installing the Adapter

1. Remove power from the drive.

2. Use static control precautions.

3. Mount the adapter on the required special drive cover (ordered

separately — see

Figure 2.4

for part numbers).

• C Frame: Use the adapter screw to secure the adapter to the cover.

• B Frame: Disregard the screw and snap the adapter in place.

Important: For C Frame drives, tighten the adapter’s lower left screw to

ground the adapter (see

Figure 2.4

). For B Frame drives,

install the special drive cover onto the drive using both
cover fasteners to ground the adapter.

4. Connect the Internal Interface cable to the DSI port on the drive and

then to the mating DSI connector on the adapter.

Figure 2.3 DSI Ports and Internal Interface Cables

Connecting the Adapter to the Drive

Item Description

➊

DSI Connector

➋

15.24 cm (6 in.) Internal Interface cable

➌

Ethernet cable

PowerFlex 40 Drive

(C Frame shown

with cover removed)

Back of Required Special Drive Cover

(ordered separately):

Part Number 22B-CCB for B Frame

Part Number 22B-CCC for C Frame

➋

EtherNet/IP Adapter

➊

➌