Rockwell Automation 20B PowerFlex 700 Drives - Frame 10 Components Replacement - Manual (Page 45)

Rockwell Automation Publication 20B-IN026B-EN-P - July 2013 45
Inverter Assembly Component Replacement Procedures Chapter 3
Power Interface Board See Chapter 1 - Component Diagrams and Torque Specifications to locate
components in these instructions.
Remove Components
1. Read and follow the
Safety Precautions on page 11 and Important Initial
Steps on page 12 .
2. Remove safety shields and enclosure covers as needed.
3. Remove the Main Control Panel. See
Main Control Panel (Inverter
Assembly) on page 22 .
4. Remove wiring to the Power Interface Board.
5. Remove wiring from the Power Interface Board to the Switch Mode Power
Supply Board.
Connector Wire Color(s) Connects To:
J1 Ribbon J2 on Main Control Board (ribbon cable)
J2 Black J1 on Switch Mode Power Supply Board
J6 Black Monitor wire to thermal sensors
J8 Red/White/Black J7-U on U Phase Gate Interface Board
J9 Red/White/Black J1 on 24V Power Supply Board
J10 Red/Black/White/Blue J3 on Precharge Board
J12 Red/White J3 on Switch Mode Power Supply Board
J13 Black J2 on Switch Mode Power Supply Board
J14 Red/White/Black U Phase Current Transducer
J15 Red/White/Black V Phase Current Transducer
J16 Red/White/Black W Phase Current Transducer
J18 Blue/White U, V, W negative (–) gates (lower phase)
J23 Orange/Black U, V, W positive (+) gates (upper phase)
J1
J10
J8
J9
J16
J15
J14
J24
J13
J23
J18
TB2
J6
TB1
J2
Spacers (9)
J12