Rockwell Automation 20B PowerFlex 700 Drives - Frame 10 Components Replacement - Manual (Page 35)

Rockwell Automation Publication 20B-IN026B-EN-P - July 2013 35
Basic Component Removal Procedures Chapter 2
8. Label any AC input cables according to which Bus Flags (R, S, or T) they
are connected.
9. Disconnect any AC input cables from the AC Bus Flags and save the
connector bolts.
10. Label the wires and remove the screw from each AC Busbar that secures
the red wires and the black wires, and save.
• Red Wire: from the R, S, or T Snubber Resistor to the R, S, or T
AC Busbar
• Black Wire: from the MOV
11. Remove the two bolts, washers, and nuts that secure each AC Busbar to
the SCR Modules, and save.
12. Remove the two set screw nuts that secure each AC Busbar to the glastic
standoffs and save.
13. Remove each AC Busbar.
Shown with AC Input Cables and Connecting Bolts Removed
AC Busbar
Mounting Bolt (2
per Busbar)
Set Screw Nut for
Glastic Standoff (2
per Busbar)
AC Bus Flags
(1 per Busbar)
MOV Wires (black) and
Corresponding Snubber
Resistor Wires (red).
(1 screw per Busbar)