SATEC PM296 - Manual (Page 65)

Chapter 7 Communications 57
Table 7-1 Printout Record Parameters
Line Place Heading Parameter Digits Unit
1 1 V1/kV1 Voltage L1/L12 5 V/kV
1 2 V2/kV2 Voltage L2/L23 5 V/kV
1 3 V2/kV3 Voltage L3/L31 5 V/kV
1 4 A1 Current L1 5 A
1 5 A2 Current L2 5 A
1 6 A3 Current L3 5 A
1 7 kW/MW Total kW 6 kW/MW
1 8 kvar/Mvar Total kvar 6 kvar/Mvar
1 9 kVA/MVA Total kVA 6 kVA/MVA
1 10 PF Total power factor 6
2 1 THDU1 Voltage THD L1/L12 5 %
2 2 THDU2 Voltage THD L2/L23 5 %
2 3 THDU3 Voltage THD L3 5 %
2 4 THDI1 Current THD L1 5 %
2 5 THDI2 Current THD L2 5 %
2 6 THDI3 Current THD L3 5 %
2 7 Hz Frequency 5 Hz
2 8 A_NEU Neutral current 5 A
2 9 U_UNB Voltage unbalance 5 %
2 10 I_UNB Current unbalance 5 %
3 1 A1_MD Maximum ampere demand L1 5 A
3 2 A2_MD Maximum ampere demand L2 5 A
3 3 A3_MD Maximum ampere demand L3 5 A
3 4 kW_MD/
MW_MD Maximum sliding window kW import
demand 6 kW/MW
3 5 kVA_MD/
MVA_MD Maximum sliding window kVA
demand 6 kVA/MVA
3 6 +MWh MWh import 7 MWh
3 7 -MWh MWh export 7 MWh
3 8 +Mvarh Mvarh import 7 Mvarh
3 9 -Mvarh Mvarh export 7 Mvarh
3 10 MVAh MVAh 7 MVAh
Readings for all electrical quantities except of energies are sliding average values.
When the value width is over the field resolution, the right most digits are truncated.
Negative (exported) energy readings are printed without a sign.
When using direct wiring (PT Ratio = 1), voltages are displayed in 0.1 V units, currents
in 0.01 A units, an powers in 0.001 kW/kvar/kVA units. For wiring via PTs (PT Ratio >
1), voltages are displayed in 1V units, currents in 0.01 A units, and powers in 0.001
MW/Mvar/MVA units. When the value width is over the window resolution, the right
most digits are truncated.