SATEC PM296 User Manual
Page 55
Chapter 5 Data Display
47
Page Window PAGE Parameter
Digits Unit
LEDs
20 8
Harmonic H39 total kW
5
kW/MW
20 9
Harmonic H39 total kvar
5
kvar/Mvar
20 11
Harmonic H39 total power factor
4
Total Energies
11
PAG. 6
Label
1 1,4,7
MVAh 9
MVAh
1 2
IP.
Label
1 5,8
MWh import
9
MWh
1 3
IP.
Label
1 6,9
Mvarh import
9
Mvarh
2 2
EP.
Label
2 5,8
MWh export
9
MWh
2 3
EP.
Label
2 6,9
Mvarh export
9
Mvarh
3 2
U-h
Label
3 5,8
Volt-hours 9
kV-h
3 3
A-h
Label
3 6,9
Ampere-hours 9
kA-h
TOU Energy Registers
1-16 10
trF.1 - tF.16
Label
1-16 11
rEG.1 - rG.16
Label
1-16
2,5,8
Tariff register reading
9
Display readings for all electrical quantities except Min/Max log and energies are
sliding average values
.
When using direct wiring (PT Ratio = 1), voltages are displayed in 0.1 V units, currents
in 0.01 A units, and powers in 0.001 kW/kvar/kVA units. For wiring via PTs (PT Ratio >
1), voltages are displayed in 1V units, currents in 0.01 A units, and powers in 0.001
MW/Mvar/MVA units. When the value width is over the window resolution, the right
most digits are truncated
By default, the maximum range for energy readings is 999,999,999 MWh/Mvarh/MVAh.
Beyond this value, the reading will roll over to zero. You can change the energy roll
value to lower limit via the User Selectable Options menu (see Section 4.11).Negative
(exported) energy readings are displayed without a sign.
Fundamental values are displayed if they are enabled in the Display Setup menu (see
Section 4.10).
Per phase power and power factor readings are displayed only in 4LN3/4LL3 and
3LN3/3LL3 wiring modes (see Section 4.1) if the phase power display is enabled in the
Display Setup
menu (see Section 4.10).
Phase voltage harmonics will be line-to-line in 3OP2 and 3OP3 wiring modes, and
line-to-neutral in any other wiring mode.
When the 4LN3 or 3LN3 wiring mode is selected, the voltages will be line-to-neutral; for
any other wiring mode, they will be line-to-line voltages.
Displayed only in the 4LN3 or 3LN3 wiring mode.
TOU energy readings are displayed in MWh/Mvarh/MVAh according to energy input
assigned to the register.