SATEC PM296 - Manual (Page 49)

Chapter 5 Data Display 41
The display is updated approximately twice per second; you can adjust the
display update rate via the Display Setup Menu (see Section 4.10).
Tables 5-1 and 5-2 list all displayed parameters and their LED indicators for the
PM296 front panel display and RDM096 remote display module.
Auto Scroll
If display Auto Scroll option is enabled (see Section 4.10), the common
measurements display (main screen)
will scroll automatically after 30 seconds of
uninterrupted use.
To stop auto scrolling at the current page, press either arrow key.
Auto Return to the Main Screen
If display Auto Return option is enabled (see Section 4.10), the display will
automatically return to the main screen from any other measurement screen after
30 seconds of uninterrupted use.
Fast Reset of Accumulated Data
When changing data via the front panel is not secured by a password, you can
reset the Min/Max registers, maximum demands and total energies from the
display mode without entering the reset menu.
NOTES
1. In the PM296, a page number at the right of the display identifies the current
measurements group. The common measurements display (main screen) is designated
by a page number of 1 through 3. The first display in this group shows a power factor
reading instead of a page number. To return to the common measurements from
another group, just press the same key that you used to display this group.
2. In the RDM096, a designated indicator LED below the display shows the current
measurements group. The common measurements display (main screen) does not
have an indicator LED. If no arrow LED is lit up below the display, this means that the
common measurement parameters are being displayed at this time. To return to the
common measurements from another group, just press the same key that you used to
display this group (the key pointed to by an illuminated arrow LED) until the illuminated
LED goes out.
3. When you move to another measurement group, the instrument stores your last
location; when you return to the previous group, the instrument restores the last page.
At power up, the instrument always returns to the common measurements group and
shows you the last page that was displayed prior to loss of power.
Selecting a Display Page
Press the down/up arrow keys to scroll through display pages.
Selecting Common Measurements (Main Screen)
In the RDM096, press the key pointed to by the illuminated arrow LED below the front
panel display. If no LED is lit up, this means that the front panel displays the common
measurements parameters.