SATEC PM296 - Manual (Page 31)

Chapter 4 Setup Menus 23
4.2 Communications Port Setup Menus
These menus allow you to access the communications port options that the
PM296/RPM096
uses to communicate with a master computer or a printer. Table
4-2 lists the communications options, their code names and applicable choices.
From the main menu, select the menu for the port you want to configure. Activate
the middle window to scroll through the list of available options, and then activate
the lower window to set the option value.
To select and view a setup option:
Press to activate the middle window.
Use the up/down arrow keys to scroll to the desired option. The option setting will
appear in the lower window.
To change the selected option:
Press to activate the lower window.
Press the up/down arrow keys to scroll to the desired value.
Press to store the selected value or press to quit the setup menu.
NOTE: An optional analog expander can be connected to Communications Port #2.
Table 4-2 Communications Options ( ∗ default setting )
COM1
Code Parameter Options Description
Prt.1 Communications
protocol
ASCII
∗
rtu
dnP3
Prnt
ASCII protocol
Modbus RTU protocol
DNP3.0 protocol
Printer mode
rS Interface standard 232 RS-232 interface
485
∗ RS-485 interface
Addr Address
0
∗-99 ASCII
1
∗-247 Modbus
0*-255 DNP3.0
Powermeter address
bAud Baud rate 110 110 baud
300 300 baud
600 600 baud
1200 1200 baud
2400 2400 baud
4800 4800 baud
9600
∗ 9600 baud
19.20 19,200 baud
38.40 38,400 baud
Prt.1
ASCII
Prot
ESC ENTER
SELECT
SELECT
SELECT CHG ENTER Prt.1 ENTER
SELECT CHG ENTER Prt.2 ENTER