Device options and mode control, In chapter 5 on how to, Device options and – SATEC EM920 Operation Manual User Manual
Page 74: Mode control, In chapter, In chapter 5), Device options and mode, Control, On how to enable and disable compensation in
Chapter 5 Configuring the EM920
General Meter Setup
74
EM920 Power Quality and Revenue Meter
Device Options and Mode Control
Using the Front Display
To enter the device options setup menu, select Options from
the main menu.
To enter the TEST mode menu, select Test Mode Setup from
the main menu. You can also directly enter the TEST menu
by extended press on the TEST button located under the
meter cover (see
See
Viewing and Changing Setup Options
information on navigating in menus.
See the table below for available options.
Using PAS
Select General Setup from the Meter Setup menu, and then
click on the Device Options tab.