SATEC EM920 Operation Manual - Manual (Page 138)

Chapter 6 Device Control and Upgrading
Reset of Accumulators and Log Files
138 EM920 Power Quality and Revenue Meter
Reset Entry Menu Function Security
Level
Diagnostic Reset of device diagnostics Low
Power MD
Volt/Amp MD
Volt MD
Ampere MD
Harmonic MD
All MD Reset of engineering maximum demands Low
Device Oper. Time Reset of the meter operation time counters Medium
Battery Oper. Time Reset of the lithium battery operation time counters Medium
Power Failures Reset of the meter failure counters Medium
To reset a desired entry:
1. Use the SCROLL button to scroll through the menu
entries until a required reset entry appears in the
window.
2. Press briefly SELECT/ENTER button to highlight the
“Do” entry.
3. Press and hold the SELECT/ENTER button for more
than 5 seconds until the “Do” entry is replaced with
“Done” indicating that the operation is complete.
4. Release the button.
If your security level does not allow access to a menu entry,
you will not be able to highlight the lower action window.
Using PAS
Select Reset from the Monitor menu. Refer to the table above
for required permissions. To clear log files, you should have
the administration rights.
EXTENDED PRESS ENTER
SHORT PRESS SELECT
SCROLL