SATEC EM920 Operation Manual - Manual (Page 70)

Chapter 5 Configuring the EM920
Configuring Communications
70 EM920 Power Quality and Revenue Meter
Parameter Options Default Description
XPW Client Enabled NO, YES NO Enables operations of the
eXpertPower client
Time to Next Session,
min 1-99999
The time remaining to the
next connection session
Connection via Network Ethernet,
GPRS/Modem
Ethernet Automatically selected
depending on the network
module installed
NOTES
1. Do not enable the eXpertPower client in your meter if
you do not use the eXpertPower TM service.
2. Do not change the connection period setting. The
eXpertPower server updates it automatically.
Setting-Up TCP Notification Client
Select Communication Setup from the Meter Setup menu,
and then click on the TCP Notification Client Setup tab.
The TCP notification client can establish connections with a
remote Modbus/TCP server and send notification messages
either on events, or periodically on a time basis. See the
EM920 Modbus Reference Guide for more information on the
client operation and the notification message layout.
The server’s IP address, port number and starting Modbus
register address are programmable in the meter.
The following table lists available options.