SATEC C192PF8-RPR - Manual (Page 62)

Chapter 6 Data Display 57
Selecting Total Harmonic Measurements
Press the key until the THD or TDD LED is illuminated. Use the
up/down arrow keys to scroll through the different harmonic parameters.
Selecting Energy Measurements
Press the key. Use the up/down arrow keys to scroll through the
different energy readings.
Fast Reset of Accumulated Data
Select a display page where the data you want to reset is displayed. To reset:
• Min/Max log registers: select a Min/Max page from the Min/Max
measurements display (where a MAX or MIN round LED is illuminated).
• Ampere and volt maximum demands: select the ampere or volt maximum
demand page from the Min/Max measurements display (where a MAX DMD
LED is illuminated, and volts or amps LEDs at the right are lit).
• Power maximum demands: select the power maximum demand page from
the Min/Max measurements display (where a MAX DMD LED is illuminated,
and kVA/MVA and kW/MW LEDs at the right are lit).
• Total and phase energies: select the energy measurements display.
While holding the key, press and hold for about 5 seconds.
The displayed data is reset to zero.
6.2 Data Display Formats
Table 5-1 specifies all front panel local displays available in the display mode.
The display windows are labeled in the table as follows: 1 = upper window, 2 =
middle window, 3 = lower window.
Table 5-1 Displayed Parameters
Page Window Indicator
LED
Parameter Digits Unit
Common Measurements
1 PF Total power factor 4
2 kVA Total kVA 4 kVA/MVA
1
3 kvar Total kvar 4 kvar/Mvar
1 V1/V1-2 Voltage L12 4 V/kV
2 V2/V2-3 Voltage L23 4 V/kV
2
3 V3/V3-1 L. Voltage L31 4 V/kV
1 V1/V1-2 Voltage L1 4 V/kV
2 V2/V2-3 Voltage L2 4 V/kV
3
3 V3/V3-1 P. Voltage L3 4 V/kV
1 A1 Current L1 4 A
2 A2 Current L2 4 A
4
3 A3 Current L3 4 A
ENERGY
SELECT ENTER
THD/TDD