RKI Instruments Beacon 410 User Manual
Page 40
36 • Viewing and Changing Channel Parameters
Beacon 410 Gas Monitor Operator’s Manual
4.
Press and release the UP /YES or DOWN/NO button until the setting you want to
select appears, then press and release the ENTER button to save it. The next channel
parameter screen appears.
NOTE:
If you selected STANDBY or NOT USED, the display will ask you if you still want
to review the channel settings. If yes, press and release the UP/YES button and
continue with step 5. If no, press and release the DOWN/NO button and proceed
to step 9.
NOTE:
Use the ESCAPE button to go backwards in the menu.
5.
In the parameter screens, use the ENTER button to accept a displayed parameter
setting and proceed to the next parameter or the ESCAPE button to backup a screen.
6.
If you want to change a displayed parameter setting, use the UP/YES or DOWN/NO
button to change the parameter to the desired setting, then press and release the
ENTER button to accept the change and proceed to the next screen.
7.
Continue through the parameter setting screens changing any parameter settings as
needed until the following message appears on the display.
8.
To save the channel parameter settings, press and release the UP /YES button.The
screen will indicate that the Beacon 410 is saving the settings for a few seconds.
If you do not want to save the channel parameter settings, press and release the
DOWN/NO button. The display will indicate that no settings have been changed for a
few seconds and the channel parameters will return to their original settings.
9.
The following screen will appear asking if you want to configure more channels.
If yes, press and release the UP/YES button to return to the Select Channel Screen.
Begin at instruction step 3 above to configure another channel.
If no, then press the DOWN /NO button to return to normal operation.
]
A
C
S
S
s
g
n
i
t
t
?
[
k
t o
b a c
u p
]
E
P
N
Y
[
e
E
a v e
S
/
D
D
[
o
o
Y
]
/ N
M o r e
C h a n n e l s ?
o
T
t
n
a
W
u
o
Y