Opticon XPT 3125 Universal menubook - Manual (Page 37)

OPTICON Universal menu book
U30
2.3.8. Memorizing
Memorizing options can be used to temporary
store bar code data in case the bar code reader
lost its connection. As soon the reader is
connected again, the temporary stored data is
transmitted to the computer and the storage
area is cleared.
The data is stored in RAM. In case the battery
is depleted or battery is removed, data is lost.
The bar code reader is automatically
disconnected in case:
• the bar code reader is out of range ( too far
away from cradle ),
• power from cradle is lost.
Data memorizing disabled:
Bar code data is not stored automatically, in
case the connection is lost. Data memorizing
can manually be started by reading the Start/
continue memorizing option.
Data memorizing enabled:
Bar code data is stored automatically, in case
the connection is lost.
Memorize after connection loss:
Data is only temporary stored in case the bar
code reader lost its connection. Memorizing
stops in case the +-DISC-+ label is read or in
case the wireless address is changed.
Always memorize when not connected:
Data is always temporary stored in case the bar
code reader is not connected.
Memorize control labels:
The next options should be used without
reading the SET and END label. These
memorizing options are intended to manually
control the memorizing mode.
Start/continue memorizing:
Manually start memorizing. In case memorized
data was present, it will continue memorizing.
Stop/pause memorizing:
Manually stop memorizing. Memorizing can be
continued by reading the Start/continue
memorizing option.
Clear all memorized data:
All memorizing data is deleted and the storage
area is cleared.
Transmit memorized data:
All memorized data will be transmitted, if a
connection is available.
Available memory for memorizing is reader
dependent ( 12kB )