Opticon XPT 3125 Universal menubook - Manual (Page 123)

OPTICON Universal menu book
U116
5.1.3. Auto trigger options
These options are used to activate the auto
trigger option of the reader. This is only
supported for reader equipped with the auto
trigger option.
Disable auto trigger:
The auto trigger function is not activated.
Enable auto trigger:
The reader will be triggered if it detects
changes in brightness.
Enable stand detection:
Support for this option is reader dependent and
a suitable stand is required. This stand
detection option enables auto trigger
automatically when the reader is inserted into
the stand. When the reader is removed from
the stand, auto trigger is disabled.
In case the option disable auto trigger or the
the option enable autotrigger is configured the
stand detection configuration is automatically
disabled.
5.2. Read time options
The length of the period that the reader is ON
after the trigger switch is pressed, or (in
multiple or continuous read mode) after a label
has been read. Selecting a read time of 0
means that the reader will stay ON as long as
the trigger switch is being pressed. Selecting a
read time for readers without a trigger switch, or
when the trigger switch is disabled, does not
have any effect.
SET
_ZZ_
Disable auto trigger +F
_+F_
Enable auto trigger +I
_+I_
Enable stand detection *4
_*4_
END
_ZZ_