Metal Sales Magna-Loc Installation - Manual (Page 42)

© Metal Sales Manufacturing Corporation / Subject to change without notice 6/12
42
MAGNA-LOC
INSTALLATION PROCEDURE OVERVIEW
The following procedures (pages 22-47) are presented as a general guide for installing Magna-Loc panels, flashings, and
accessories on a typical building or residence. Details are shown for installing Magna-Loc and related flashings over solid
decking and over open framing. For other applications please contact your nearest Metal Sales location (See pages 2 and 3).
The installation procedures will involve:
• Installation of Floating Rake Zee. (page 22)
•
Installation of Eave plate.
• Installing panel from left to right (Looking from Eave to Peak.)
• Panel Clip installation.
• Endlapping of panel.
• Sidelapping of panel.
• Termination of panel.
• Seaming panels.
• Eave condition installation.
• Gutter condition installation.
• Valley condition installation.
•
Endlap condition installation.
• Rake condition installation.
• Rakewall condition installation.
• Expansion Joint condition installation.
• Endwall condition installation.
• High Side Eave condition installation.
• Ridge / Hip condition installation.
Ridge (See Pages 66-68)
Magna-Loc Panel (See Pages 8-10)
End Dam (See Page 78)
Floating Rake Zee (See Page 43)
SSR Rake Cleat (See Pages 59 & 61)
Rake (Off Module)
(See Pages 60)
Gutter Support
(See Page 55)
Gutter
(See Page 55)
Eave Plate
(See Page 44)