Metal Sales Magna-Loc Installation - Manual (Page 41)

© Metal Sales Manufacturing Corporation / Subject to change without notice 6/12
41
MAGNA-LOC
Factory Notched Panels - Metal Sales can provide factory notched panel ends to eliminate material-build up or reliance on
field notching for weathertight seams at panel endlaps.
Factory Pre-punched Panels - Metal Sales can provide panels that have been factory punched with holes for proper placement
of fasteners at panel endlaps.
STANDARD PANEL:
 Used when endlapping of panels is not required
 One panel from eave to peak of roof
 No notching
 No punching
PEAK PANEL:
 Used when endlapping of panels is required
 Used as upper panel of endlapping run
 Pre punched holes for endlap fastener placement
 No notching
*Panel is notched and punched both ends or neither
MID PANEL:
 Used on runs where more than (2) panels are needed from eave to
peak
 Not required if only (2) panels are used from eave to peak
 Notched for panel endlapping
 Pre-punched holes for endlap fastener placement
EAVE PANEL:
 Used when endlapping of panels is required
 Used as lower panel of endlapping run
 Notched for panel endlapping
 No punching
*Panel is notched and punched both ends or neither
**Notch trailing end only
One panel - Eave to Peak
Two or more panels - Eave to Peak
Standard Panel
Eave Eave
Peak Peak
Peak Panel
Mid Panel
Eave Panel
*Longmont, CO
**Sellersburg, IN
*Longmont, CO
**Sellersburg, IN
*Longmont, CO
**Sellersburg, IN
*Longmont, CO
**Sellersburg, IN
DESIGN / INSTALLATION CONSIDERATIONS (
cont
.)