JUMO 707050 dTRANS T05 - Programmable 2-Wire Transmitter Operating Manual - Manual (Page 69)

31
6 Appendix
6.1.4 Output
6.1.5 Customer-specific linearization
Type 707050 Type 707051
Output signal Load-independent direct current: Load-independent direct current:
Free setting: 4 to 20 mA or 20 to 4 mA Free setting: 4 to 20 mA or 20 to 4 mA
Voltage signal:
Free setting: 0 to 10 V or 10 to 0 V
Electrical isolation Between input and output: Between input and output:
Test voltage Û = 3.75 kV/50 Hz Û = 1.875 kV/50 Hz
Transmission behavior Linear, temperature-linear
Customer specific
Reversion of the output signal
Step response 0 to 100 % < 2 s (with filter constant 0 s)
Switch-on delay 5 s (correct measured value after the supply voltage is applied)
Current output
Load (R
b
) R
b
= (U
b
- 11 V)/0.022 A
Load error  ±0.02 %/100 
Calibration conditions/accu-
racy DC 24 V at approx. 22 °C/±0.05 %
a
Voltage output
Load resistance  2 k
Load influence ± 15 mV
Residual ripple ± 1 % referring to 10 V, 0 to 90 kHz
Calibration conditions/accu-
racy DC 24 V at approx. 22 °C/±0.05 % b
a All specifications refer to the measuring range end value of 20 mA
b
All specifications refer to the measuring range end value of 10 V
Method Characteristics
Pairs of values Max. number: 40
Interpolation: linear
Formula Number of coefficients: 5
Polynomial: 4th order