Brother HL-2400C Series - Manual (Page 36)

CHAPTER 2 SETTING UP THE PRINTER
2–9
Installing the Oil Bottle and the Fuser Cleaner
1. Release the Fusing unit pressure a little with the Pressure Release
Levers (
). Then pull the orange protective parts between the rollers
of the Fusing Unit out to remove them (
). Make sure that the
Pressure Release Levers are locked.
Fig. 2-13 Remove the Protective Parts
2. Install the Oil Bottle into the Fusing Unit with the label side facing the
front of the printer.
Fig. 2-14 Install the Oil Bottle
!
Caution
Do not spill the oil inside the printer. If the oil does spill, it might cause
damage to the printer. If you do spill any oil, consult your dealer or our
authorized service representative.