Brother HL-2400C Series - Manual (Page 166)

CHAPTER 5 MAINTENANCE
5-25
3. Install the new Transfer Roller by putting the left side pin of the
Transfer Roller into the boss on the left hand side of the unit. Adjust
and place the right side knob of the Transfer Roller into the holder.
Fig. 5-31 Install the Transfer Roller
4. Lock the Transfer Roller with the Transfer Roller Lock Levers.
5. Close the Rear Access Cover.
6. Plug in the printer and press the Power button to turn the printer on.
7. Press the Sel button and make the printer Off Line.
8. Press the Reset button while holding down the Shift button.
9. When you see “RESET PRINTER” on the LCD panel, press the ▲
(UP) or ▼ (DOWN) button and select “RESET PARTS LIFE” . Press
the
Set button and select “120K KIT” with the ▲ (UP) or ▼ (DOWN)
button.
10. Press the Set button and the printer printer becomes On Line.