Brother HL-2400C Series - Manual (Page 110)

CHAPTER 4 CONTROL PANEL
4–47
FONT Button
Pressing the Font button allows you to select fonts and symbol/character
sets.
✒ Notes
When you use the
Font button, note the following:
The Font button is effective in the HP PCL5C, EPSON FX-850, and
IBM Proprinter XL modes. However the settings are subject to the
current emulation mode. Note that the
Font button does not work in
the BR-Script 2 mode.
If the application software supports font and symbol/character set
selection, you do not need to set them with the
Font button. The
software or command setting overrides the button setting.
If you want to use optional fonts other than the printer’s resident
fonts, be sure to install a font cartridge/card that has your desired
fonts. The printer automatically selects the font that has exactly the
same or similar characteristics as those you set through the software or
with a command. If the installed font cartridge/card happens to have a
font of similar characteristics, the printer will print with an
unexpected font.
You can store the fonts you require on a flash memory card or HDD
card only in the HP PCL5C mode or BR-Script 2 mode when one is
installed. See “CARD OPERATION.”
Setting the Font and Symbol Set in the HP PCL5C Mode
When the HP PCL5C emulation mode has been selected, the font and
symbol set can be set separately as the primary or secondary font.
When the primary font is selected;
Message on the lower row to do;
SELECT FONT P Set the primary font
SYMBOL SET P Set the symbol set
TABLE PRINT P Print the code table
When the secondary font is selected;
Message on the lower row to do;
SELECT FONT S Set the secondary font
SYMBOL SET S Set the symbol set
TABLE PRINT S Print the code table