Brother HL-2400C Series - Manual (Page 159)

USER’S GUIDE
5-18
✒ Note
When you start using a new Fusing Unit, it is possible that initially poor
fixing may occur. If it does, please wait for a while until the oil penetrates
through to the Heat Roller.
4. Take out the Fusing Unit from the printer by holding the handles on
both sides.
Fig. 5-19 Take out the Fusing Unit from the Printer
!
Caution
When taking the Fusing unit out of the printer, be sure to keep the Fusing
Unit flat, so that oil will not be spilt.
5. Remove the Oil Bottle and the Fuser Cleaner from the Fusing Unit.
6. Install the new Fusing Unit into the printer. Insert the Fusing unit fully
down into the correct position.
Fig. 5-20 Installing the New Fusing unit