Brother HL-2400C Series - Manual (Page 105)

USER’S GUIDE
4–42
To lock or unlock the panel buttons as above, you need to enter a 3-digit
pass number.
Change the first digit of the number with the ▲ or ▼ button and move to
the next digit with the
Set button. After you finish entering your 3-digit
pass number, the panel buttons are locked or unlocked.
✒ Note
Do not forget your pass number that you have used to lock the panel
buttons. If you enter a wrong number, you cannot unlock them. The
display shows the following message:
INCORRECT!!
■ Auto Form Feed
If unprinted data remains in the printer’s memory, the Data LED stays
on. You need to print out the remaining data with the Form Feed button.
See “FORM FEED Button” in Chapter 4.
The auto form feed mode you can set in this menu allows you to print out
the remaining data without pressing the
Form Feed button.
You can turn on or off the auto form feed in this mode menu as follows:
Display Message Auto Form Feed
AUTO FF=OFF Turn off the auto form feed. You need to
press the
Form Feed button every time
data remains in the printer’s memory.
(Factory setting)
AUTO FF=ON Turn on the auto form feed. Every time data
remains in the printer’s memory, an auto
form feed takes place after the wait time set
as below.
When you turn on the auto form feed as above, you need to set the wait
time in the following sub-setting menu:
Display Message Wait Time
WAIT TIME= 1s Set the wait time for the auto form feed.
. The printer automatically prints out the
. remaining data after the set wait time.
WAIT TIME=99s The wait time can be set from 1 to 99
seconds.