Brother HL-2400C Series - Manual (Page 172)

CHAPTER 5 MAINTENANCE
5-31
✒ Note
Do not load B5 or smaller size paper and envelopes in the cassette which
is loaded into the optional Lower Tray Unit. It might cause paper jams.
Font Card, Flash Memory/HDD Card
Installing a Font Card, Flash Memory Card and HDD Card
This printer has two slots for an optional font cartridge and one slot for an
optional font card, flash memory card or HDD card. (Type III HDD cards
will only fit into card slot 2.)
If you have installed optional font card(s), you can use the fonts stored in
them as well as the resident fonts. For optional font cards, consult the
dealer where you purchased the printer.
If you have installed an optional flash memory card or HDD card, you
can save macros and fonts on it. For flash memory card and HDD card
operations and information, see “CARD OPERATION” in Chapter 4.
✒ Notes
Do not install or remove cards with the printer power on, or you may
lose all data from the card, or may seriously damage the card.
For more information about the cards, consult the dealer where you
purchased the printer.
For the latest information: http://www.brother.com
Follow these steps to install or remove a cartridge/card:
1. Make sure that the printer is turned off.
If the printer is turned on, be sure to press the Sel button to set the
printer off-line. If data remains in the printer memory, the Data LED
stays on. Press the Form Feed button to print out the remaining data,
then the Data LED goes off. Turn off the printer.
2. Insert an HDD card into slot 2 with the label facing to the right. It is
not possible to fit a card into slot 1 with a Type III PCMCIA card
fitted in slot 2.
3. Fit a flash memory or font card into either slot 1 or slot 2 with the
label facing to the right. Make sure they are inserted correctly.
To remove a card, pull it out of the slot with the printer turned off.