ETC Unison DRd Semi-Recessed Installation Kit - Manual (Page 2)

E T C I n s t a l l a t i o n G u i d e
DRd Semi-Recessed Installation Kit
DRd Semi-Recessed Installation Kit Installation Guide Page 2 of 8 Electronic Theatre Controls, Inc.
Prepare for Installation
Where to Install the Rough-in
The DRd Semi-Recessed installation kit is designed to allow installation of a DRd rack into a wall cavity,
between 2”x4” or 2”x6” framed wall studs. The installation depth of the rough-in enclosure determines
how much the DRd rack enclosure will extend from the finished surface.
DRd Rack Enclosure Specification and Installation
Reference the DRd Rack Enclosure Installation Manual for rack installation details, including all
mechanical, electrical and control wire requirements.
Rough-in Dimensions
C A U T I O N : Unison DRd rack enclosures require at least 17” (432mm) of front clearance and 6”
(152mm) of clearance to the left of the DRd rack door hinge from walls or other
equipment to allow for installation and removal of modules after installation.
If you do not allow this clearance, energization, operation and maintenance of your
DRd rack enclosure will be significantly difficult.
Kit Type
Height Width Depth
Semi-
recessed kit
Product
Weight
inches mm inches mm inches mm lbs kgs
DRd6 Semi-Recessed kit 32.25 819 20 448 4 102 15 6.8
DRd12 Semi-Recessed kit 41.5 1,054 20 448 4 102 19 9
DRd6 kit
32.25”
(819mm)
DRd12 kit
41.5”
(1,054mm)
Both kits are
20” (559mm)
Both kits are
4” (102mm)
The dimensions in the table below are provided for the
rough-in only and do not include the cover or DRd rack
measurements for depth.
It is recommended that you install the rough-in at least
36” (915mm) off the floor surface to ensure clear view
of the user interface.
The wall framing and blocking must be strong enough
to hold the semi-recessed kit and DRd rack fully
populated with modules, conduit and wire
(approximately 140 lbs / 63.5kg).
The weights noted below are specific to the rough-in
only and do not include conduit, hardware, cable, rack
and module weights.
For accurate, application-specific, DRd rack enclosure
and module weights, reference the Unison DRd Rack
Enclosure Installation Manual.