Dascom LA550W User Guide - Manual (Page 77)

User guide The Menu
69
Paper handling (Paphand) The Paphand group of menus improves the possibilities for the trou-
blefree printing of paper with properties likely to cause problems
(perforations etc.) or paper of poor finish.
Put the printer into Menu mode by pressing the Setup key. Press the
Menu key. The display shows Print/Macro. Press Next or Back key
until the parameter group Paphand/CX-bid appears in the display.
Press the Paphand key (2).
Select the Head up menu (2).
Increasing the print head gap
(Head up)
With this function you can increase the print head gap before and af-
ter the perforation of the form.
Setting options: On/Off
Default setting: Off
If the parameter is set to On, the print head gap increases during
form feed and line feed four lines before and after the perforation on
the form (= protected zone). The print head gap is always increased
during form feeding past the perforation even when feeding takes
place outside the protected zone.
Printing is possible in the protected area.
Confirm the setting by pressing the Set (1) key.
Paphand CX-bid
Online
Setup
Back Next
2 1 3 4
Head up Pagewid
Online
Setup
Back Next
2 1 3 4
Head up=Off *
Online
Setup
Set < > Exit
2 1 3 4
1
2
2
3
4
5
6
7 8
1 Top edge of form 5 Protected zone
2 Paper transport strip 6 Transport holes
3 Bottom edge of form 7 Left-hand area
4 Form separation perforation 8 Right-hand area