Setup mode – Dascom LA550W User Guide User Manual
Page 31
User guide
The control panel
23
Setup mode
In this mode, the following settings are available:
`
Setup key: Sets the printer to Setup mode, in which the following
settings can be selected:
`
Menu key (1): Other menu settings. Acces may be disabled by
the manufacturer (see note below).
`
Adjust key (2): Sets the Tear position, first printing line and print
head gap.
`
Paprpath key (3): Sets the paper path.
`
Char key (4): Sets the font and number of characters per inch.
Access to the other menu settings (Menu) may be – depending
on the model – disabled by the manufacturer.
Proceed as follows to release this lock temporarily.
1 Switch off the printer for approx. 5 seconds.
2 Switch the printer on again keeping the Setup key pressed until
Selftest disappears on the display.
For information on how to enable access permanently and
about the available settings, refer to the section
and
The settings for Font and CPI are lost when the printer is
switched off. The section
Horizontal spacing of characters (CPI)
(page 86) explains how to set fonts and character density per-
manently.
Adjust
Paprpath
Menu
Char
Online
Setup
2
1
3
4