beautypg.com

Messages in the lc display – Dascom LA550W User Guide User Manual

Page 32

background image

User guide

The control panel

24

Messages in the LC
display

If the printer detects an internal fault or user error or if it expects you
to do something, a message will appear in the LC display. It also dis-
plays the status during an operation (e.g. Loading default). Below
you will find a list of messages with brief descriptions of each mes-
sage. The messages are described in greater detail in the chapter

Error messages via the display (page 102)

.

Message

Meaning

Eject error

The printer cannot eject the paper /
advance it to park position.

Hardware Alarm

Internal hardware error, contact your
dealer or service technician.

Head hot

The printer reports that the print head is
hot and that print speed will be reduced.

Initializing

This message appears during the
printer’s initializing phase.

Load error

The printer cannot draw in the loaded
paper.

Loading default

Indicates that the printer is being initia-
lised and is carrying out the internal self-
test immediately after turning on the
printer. Factory defined parameters will
be reloaded in all available menues.

Out of paper

The printer has detected paper end dur-
ing operation / printer was switched on
with no paper loaded.

Parity error

A parity error during data transmission is
indicated.

Press any key

The user is requested to press any key.

Tear Paper off

The user is requested to tear off paper
which has been advanced to the quick
tear edge.

Selftest

After power-on, the printer executes a
short hardware self-test.

This manual is related to the following products: