Setting line spacing (lpi) – Dascom LA550W User Guide User Manual
Page 58
User guide
The Menu
50
Setting line spacing (LPI)
Sets the lines per inch (line density). The higher the parameter the
smaller the line spacing (random LPI can be selected via the ESC
sequences).
Press LPI (2) key.
Use the
<
(2) or
>
(3) key to select the desired setting.
Setting Options: 2 LPI, 3 LPI, 4 LPI, 6 LPI*, 8 LPI, 12 LPI
Default Setting: 6 LPI
Confirm the setting by pressing the Set key (1). Press the Next key
(4) to access the next group of parameters.
Selecting start signal for
escape sequence (ESC-
Char)
Selects the start signal for control sequences. Setting ESC: Only
character Escape (27d, 1Bh) can be used. Setting ESC+$$: Char-
acter Escape or alternatively two $ characters ($$) can be used. For
more information see the section
Press ESCChar (2) key.
Use the
<
(2) or
>
(3) key to select the desired setting.
Setting Options: ESC/ESC+$$
Default Setting: ESC
Confirm the setting by pressing the Set key (1).
Font
LPI
Online
Setup
2
1
3
4
Back
Next
6 LPI
*
Online
Setup
Set
<
>
Exit
2
1
3
4
ESCChar Protocol
Online
Setup
2
1
3
4
Back
Next
ESCChar=ESC
*
Online
Setup
Set
<
>
Exit
2
1
3
4