Selecting character density and font temporarily – Dascom LA550W User Guide User Manual
Page 48
User guide
Settings
40
Selecting character
density and font
temporarily
You can use the CPI (Character Per Inch) key in Setup mode to sel-
ect the number of characters per inch to be printed.
You can use the Font key to select resident fonts.
Press the Setup key. The printer changes to Setup mode.
Press the Char (4) key.
Press the CPI (4) or Font (1) key (in our example, press CPI).
Use the
<
(2) or
>
(3) key to set the desired character density. Con-
firm the selection by pressing the Set (1) key.
You can cancel the selection and leave the setting unchanged by
pressing the Exit (4) key.
If you pressed the Font (1) key, use the
<
(2) or
>
(3) key to select
the desired font. Confirm the selection by pressing the Set (1) key.
You can cancel the selection and leave the setting unchanged by
pressing the Exit (4) key.
Press the Setup key. The printer returns to the initial status.
It is also possible to press the Online key. The printer then changes
directly to Online mode.
The selection made will not be retained after switching off the
printer. For more details on how to set the character density
and fonts permanently, please refer to the chapter
(page 76), (page 82), (page 86) and
Adjust
Paprpath
Menu
Char
Online
Setup
2
1
3
4
Font
CPI
Online
Setup
2
1
3
4
10 CPI
*
Set
<
>
Exit
Online
Setup
2
1
3
4
ROMAN
HQ
Set
<
>
Exit
Online
Setup
2
1
3
4
Adjust
Paprpath
Menu
Char
Online
Setup
2
1
3
4