Dascom LA550W User Guide - Manual (Page 45)

User guide Settings
37
Settings
This section describes how to set the tear position, the first printing
line, the print head gap as well as the font and the character density.
Setting the tear
position
If the tear position of the paper is not aligned with the tear edge of
the printer, you can adjust it. Inserted paper needs to be torn off if
necessary and retracted to park position.
Press the Setup key. The printer changes to Setup mode.
Press the Adjust (2) key.
Press the Tear (4) key.
Press the < (2) or > (3) key to move the perforation to the desired
position. Confirm the input by pressing the Set (1) key. Confirm the
input again by pressing the Setup key. The printer is reset to the in-
itial status.
The correction made – a maximum of approx. 1" (2.5 cm) in
each direction – will be retained after switching the printer off.
It can be set separately for each paper path.
Make sure that the set form length corresponds to the actual
length of the forms you are using.
7
Adjust Paprpath
Menu Char Online
Setup
2 1 3 4
TOF
Head Tear Online
Setup
2 1 3 4
TearAdj= 00/72"*
Set
< > Exit Online
Setup
2 1 3 4