beautypg.com

3 glossary – AirLive WN-5000R User Manual

Page 105

background image

WN-5000R User’s Manual

102

4-3 Glossary

Default Gateway (Router):

Every non-router IP device needs to configure a default gateway’s IP address.

When the device sends out an IP packet, if the destination is not on the same network, the device has to send

the packet to its default gateway, which will then send it out towards the destination.

DHCP:

Dynamic Host Configuration Protocol. This protocol automatically gives every computer on your home

network an IP address.

DNS Server IP Address:

DNS stands for Domain Name System, which allows Internet servers to have a

domain name (such as www.Broadbandrouter.com) and one or more IP addresses (such as 192.34.45.8). A

DNS server keeps a database of Internet servers and their respective domain names and IP addresses, so

that when a domain name is requested (as in typing "Broadbandrouter.com" into your Internet browser), the

user is sent to the proper IP address. The DNS server IP address used by the computers on your home

network is the location of the DNS server your ISP has assigned to you.

DSL Modem:

DSL stands for Digital Subscriber Line. A DSL modem uses your existing phone lines to

transmit data at high speeds.

Ethernet:

A standard for computer networks. Ethernet networks are connected by special cables and hubs,

and move data around at up to 10/100 million bits per second (Mbps).

Idle Timeout:

Idle Timeout is designed so that after there is no traffic to the Internet for a pre-configured

amount of time, the connection will automatically be disconnected.

IP Address and Network (Subnet) Mask:

IP stands for Internet Protocol. An IP address consists of a series

of four numbers separated by periods, that identifies a single, unique Internet computer host in an IP network.

Example: 192.168.2.1. It consists of 2 portions: the IP network address, and the host identifier.

The IP address is a 32-bit binary pattern, which can be represented as four cascaded decimal numbers

separated by “.”: aaa.aaa.aaa.aaa, where each “aaa” can be anything from 000 to 255, or as four cascaded

binary numbers separated by “.”: bbbbbbbb.bbbbbbbb.bbbbbbbb.bbbbbbbb, where each “b” can either be 0

or 1.

A network mask is also a 32-bit binary pattern, and consists of consecutive leading

1’s followed by consecutive trailing 0’s, such as

11111111.11111111.11111111.00000000. Therefore sometimes a network mask can also be described simply

as “x” number of leading 1’s.

When both are represented side by side in their binary forms, all bits in the IP address that correspond to 1’s

in the network mask become part of the IP network address, and the remaining bits correspond to the host ID.

This manual is related to the following products: