AirLive IP-2000VPN - Manual (Page 62)

• If you prefer to use a single setup screen instead of a Wizard, click the Setup Screen button. This is
recommended for experienced users only.
• Otherwise, click Next to continue. You will see a screen like the following.
General Settings
Policy Name
Enter a suitable name. This name is not supplied to the remote VPN. It is used only
to help you manage the policies.
Enable Policy Enable or disable the policy as required. For each remote VPN, only 1 policy can
be enabled at any time.
Allow NetBIOS
traffic
Enable this if you require NetBIOS traffic to be transferred through the VPN tunnel.
NetBIOS is used by Microsoft (Windows) networking. This setting should not be
enabled unless necessary, because it increases traffic volume.
Remote VPN
Endpoint
The Internet IP address of the remote VPN endpoint (Gateway or client).
• Dynamic. Select this if the Internet IP address is unknown. In this case, only
incoming connections are possible.
• Fixed. Select this if the remote endpoint has a fixed Internet IP address. If
selected, enter the Internet IP address of the remote endpoint.
• Domain Name. Select this if the remote endpoint has a Domain Name
associated with it. If selected, enter the Domain Name of the remote endpoint.
Keys Select Manually assigned or IKE (Internet Key Exchange) as required.
If you are setting up both endpoints, using IKE is recommended.
AirLive IP-2000VPN User’s Manual 59