AirLive IP-2000VPN User Manual

Page 16

AirLive IP-2000VPN User’s Manual

Configure or use any of the following:

• Configuration File backup and restore.
• Network

Diagnostic

• PC

Database

• Remote

Administration

• Routing
• Upgrade

Firmware

• UPnP

Chapter 10:

Other Features and

Settings

Configuration Program

The IP-2000VPN contains an HTTP server. This enables you to connect to it, and configure it using your Web

Browser. Your Browser must support JavaScript. The configuration program has been tested on the

following browsers:

• Netscape v4.08 or later

• Internet Explorer v4 or later

Preparation

Before attempting to configure the IP-2000VPN, please ensure that:

• Your PC can establish a physical connection to the IP-2000VPN. The PC and the IP-2000VPN must

be directly connected (using the switch ports on the IP-2000VPN) or on the same LAN segment.

• The IP-2000VPN must be installed and powered ON.

• If the IP-2000VPN’s default IP Address (192.168.1.1) is already used by another device, the other

device must be turned OFF until the IP-2000VPN is allocated a new IP Address during configuration.

Using UPnP

If your Windows system supports UPnP, an icon for the IP-2000VPN will appear in the system tray, notifying

you that a new network device has been found, and offering to create a new desktop shortcut to the

newly-discovered device.

• Unless you intend to change the IP Address of the IP-2000VPN, you can accept the desktop

shortcut.

• Whether you accept the desktop shortcut or not, you can always find UPnP devices in My Network

Places

(previously called Network Neighborhood).

• Double - click the icon for the IP-2000VPN (either on the Desktop, or in My Network Places) to start

the configuration. Refer to the following section 錯誤! 找不到參照來源。 for details of the initial

configuration process.