AirLive IP-2000VPN - Manual (Page 24)

3.2 LAN
Use the LAN link on the main menu to reach the LAN screen. An example screen is shown below.
Data - LAN Screen
TCP/IP
IP Address IP address for the IP-2000VPN, as seen from the local LAN. Use the
default value unless the address is already in use or your LAN is using a
different IP address range. In the latter case, enter an unused IP
Address from within the range used by your LAN.
Subnet Mask The default value 255.255.255.0 is standard for small (class "C")
networks. For other networks, use the Subnet Mask for the LAN
segment to which the IP-2000VPN is attached (the same value as the
PCs on that LAN segment).
DHCP Server
• If enabled, the IP-2000VPN will allocate IP Addresses to PCs
(DHCP clients) on your LAN when they start up. The default (and
recommended) value is Enabled.
• If you are already using a DHCP Server, this setting must be
disabled, and the existing DHCP server must be re-configured to
treat the IP-2000VPN as the default Gateway. See the following
section for further details.
• The
Start IP Address and Finish IP Address fields set the values
used by the DHCP server when allocating IP Addresses to DHCP
clients. This range also determines the number of DHCP clients
supported.
See the following section for further details on using DHCP.
Buttons
Save Save the data on screen.
Cancel The "Cancel" button will discard any data you have entered and reload
the file from the IP-2000VPN.
AirLive IP-2000VPN User’s Manual 21